Prontosan Solution for washing wounds, bottle, 350 ml

Release form

Solution for washing wounds

Packaging

Bottle 350 ml

pharmachologic effect

Healing of the wound surface can be slowed down by the presence of exudate in the wound, formations in the form of films, crusts and scabs of dead tissue and cellular detritus and / or biofilms.

These coatings are difficult to remove and create good conditions for the growth of pathogenic microflora.

In addition, even outwardly clean wounds, especially post-traumatic ones, can be contaminated with microorganisms that can cause infectious complications in the wound.

Prontosan allows you to thoroughly cleanse the wound surface, moisturize the wound and suppress the bacterial flora, which creates the conditions for early wound healing.

Thanks to the antibacterial component, Prontosan can be successfully used to prevent infection of wounds with pathogenic microorganisms and to prevent the development of infectious complications in the wound.

Indications

Prontosan Wound Solution can be used to wash and cleanse:

purulent-necrotic wounds of various origins, including long-term non-healing wounds, such as trophic ulcers, bedsores, etc .

post-traumatic wounds with the presence of foreign and necrotic tissues

thermal and chemical burns, especially in lesions with a large amount of necrotic tissue and scab

wound surfaces around stomas, catheters or probes

postoperative wounds.

Contraindications

Individual intolerance to the components of the drug.

Avoid contact with eyes and hyaline cartilage, in case of contact, rinse thoroughly with saline.

special instructions

Prontosan does not have allergenic and irritating properties, is painlessly applied to the wound surface, does not inhibit the development of granulations and does not interfere with wound epithelialization.

In order to avoid reinfection of the wound, the vials directly touching the surface of the wound must be thrown away immediately after use.

Structure

Active ingredients: 0.1% undecylene amidopropyl betaine

0.1% polyaminopropyl biguanide (polyhexanide)

Method of administration and dosage

The surface of the wound must be thoroughly washed and cleaned with Prontosan solution to remove foreign and necrotic tissues, exudate, surface films and crusts, fibrin and biofilms.

In order to reduce the risk of introducing microbes into the wound, it is recommended to cleanse as much of the area around the wound as possible with Prontosan solution.

Gauze wipes or other types of dressings soaked in Prontosan solution can be used to cleanse and moisturize the wound surface according to their instructions.

Due to the relatively low water-holding capacity of the solution (unlike Prontosan gel), dressings should be carried out at least once a day, and preferably several times a day.

To remove copious accumulations of fibrin, thicker films, crusts, scabs, etc.

it is recommended to continue treating the wound with Prontosan gel.

Wound washing with Prontosan solution should be performed at such a frequency that will be sufficient to completely remove all films and necrotic tissues and achieve optimal wound cleansing to accelerate its healing or for the subsequent stage of surgical treatment.

For washing large wound surfaces, as well as wounds in hard-to-reach places, it is recommended to treat the entire affected organ or part of the body with Prontosan solution for at least 15 minutes.

Prontosan solution can be warmed to body temperature immediately before use

To remove denser films, crusts and scabs, in the presence of abundant accumulations of fibrin, densely lying necrotic tissues, etc., it is recommended to continue treating the wound with Prontosan gel.

The wound surface should be covered with a layer of gel at least 3 mm thick.

Prontosan is applied to the wound or injected into the wound cavity.

From above, the layer of gel is covered with two or three sterile gauze wipes or other dressings.

Dear Clients!

We would like to draw your attention to possible changes in the packaging design.

Qualitative

The characteristics of the product remain unchanged.

Delivery is subject to stock availability.

INN / Active ingredient

undecylene amidopropyl betaine, polyaminopropyl biguanide (polyhexanide)

Dosage

0.1% + 0.1%

Structure

Active ingredients: 0.1% undecylene amidopropyl betaine

0.1% polyaminopropyl biguanide (polyhexanide)

Specifications

Category

Antiseptics and disinfectants

Package quantity, pcs

one

Scope of the medicinal product

General

Release form

Solution

Way of introduction

On the skin

Shelf life after opening

8 weeks

Brand name

bbraun

A type

Mouthwash

Expiration date in days

1095

Package weight, g

410

Mode of application

:

The surface of the wound must be thoroughly rinsed and cleaned with Prontosan solution to remove foreign and necrotic tissue, exudate, superficial films and crusts, fibrin and biofilms. < br> Prontosan solution. < br> Gauze wipes or other types of dressings soaked in Prontosan solution can be used to cleanse and moisturize the wound surface according to their instructions. Due to the relatively low water-holding capacity of the solution (in contrast to Prontosan gel), dressings should be carried out at least once a day, and preferably several times a day. < br> To remove abundant accumulations of fibrin, denser films, crusts, scabs, etc. ... it is recommended to continue treating the wound with Prontosan gel.< br> Wound washing with Prontosan solution should be performed at such a frequency that will be sufficient to completely remove all films and necrotic tissues and achieve optimal wound cleansing to accelerate its healing or for the subsequent stage of surgical treatment. < br> For washing large wound surfaces, and also wounds in hard-to-reach places are recommended to treat the entire affected organ or part of the body with Prontosan solution for at least 15 minutes. < br> Prontosan solution can be warmed up to body temperature immediately before use < br> < br> To remove thicker films, crusts and scab, in the presence of abundant accumulations of fibrin, densely lying necrotic tissues, etc., it is recommended to continue treating the wound with Prontosan gel. < br> The wound surface should be covered with a layer of gel at least 3 mm thick. Prontosan is applied to the wound or injected into the wound cavity. From above, the layer of gel is covered with two or three sterile gauze wipes or other dressings. Prontosan should remain on the wound until the next dressing. Dressings are done daily. As the wound is cleared of necrotic tissue, dressings can be done every other day. < br> < br> Depending on when the next dressing is scheduled, a different amount of Prontosan gel can be applied, with a layer of 3 to 5 mm thick. The application of the gel should be carried out at such a frequency that will be sufficient to completely remove all films and necrotic tissue and achieve optimal cleaning of the wound to accelerate its healing or for the subsequent stage of surgical treatment.Prontosan is applied to the wound or injected into the wound cavity. From above, the gel layer is covered with two or three sterile gauze napkins or other dressings. Prontosan should remain on the wound until the next dressing. Dressings are done daily. As the wound is cleared of necrotic tissue, dressings can be done every other day. < br> < br> Depending on when the next dressing is scheduled, a different amount of Prontosan gel can be applied, with a layer of 3 to 5 mm thick. The application of the gel should be carried out at such a frequency that will be sufficient to completely remove all films and necrotic tissue and achieve optimal cleaning of the wound to accelerate its healing or for the subsequent stage of surgical treatment.Prontosan is applied to the wound or injected into the wound cavity. From above, the gel layer is covered with two or three sterile gauze napkins or other dressings. Prontosan should remain on the wound until the next dressing. Dressings are done daily. As the wound is cleared of necrotic tissue, dressings can be done every other day. < br> < br> Depending on when the next dressing is scheduled, a different amount of Prontosan gel can be applied, with a layer of 3 to 5 mm thick. The application of the gel should be carried out at such a frequency that will be sufficient to completely remove all films and necrotic tissue and achieve optimal cleaning of the wound to accelerate its healing or for the subsequent stage of surgical treatment.From above, the gel layer is covered with two or three sterile gauze napkins or other dressings. Prontosan should remain on the wound until the next dressing. Dressings are done daily. As the wound is cleared of necrotic tissue, dressings can be done every other day. < br> < br> Depending on when the next dressing is scheduled, a different amount of Prontosan gel can be applied, with a layer of 3 to 5 mm thick. The application of the gel should be carried out at such a frequency that will be sufficient to completely remove all films and necrotic tissue and achieve optimal clearance of the wound to accelerate its healing or for the subsequent stage of surgical treatment.From above, the gel layer is covered with two or three sterile gauze napkins or other dressings. Prontosan should remain on the wound until the next dressing. Dressings are done daily. As the wound is cleared of necrotic tissue, dressings can be done every other day. < br> < br> Depending on when the next dressing is scheduled, a different amount of Prontosan gel can be applied, with a layer of 3 to 5 mm thick. The application of the gel should be carried out at such a frequency that will be sufficient to completely remove all films and necrotic tissue and achieve optimal clearance of the wound to accelerate its healing or for the subsequent stage of surgical treatment.As the wound is cleared of necrotic tissue, dressings can be done every other day. < br> < br> Depending on when the next dressing is scheduled, a different amount of Prontosan gel can be applied, with a layer of 3 to 5 mm thick. The application of the gel should be carried out at such a frequency that will be sufficient to completely remove all films and necrotic tissue and achieve optimal cleaning of the wound to accelerate its healing or for the subsequent stage of surgical treatment.As the wound is cleared of necrotic tissue, dressings can be done every other day. < br> < br> Depending on when the next dressing is scheduled, a different amount of Prontosan gel can be applied, with a layer of 3 to 5 mm thick. The application of the gel should be carried out at such a frequency that will be sufficient to completely remove all films and necrotic tissue and achieve optimal cleaning of the wound to accelerate its healing or for the subsequent stage of surgical treatment.which will be sufficient to completely remove all films and necrotic tissues and achieve optimal wound cleansing to accelerate its healing or for the subsequent stage of surgical treatment.which will be sufficient to completely remove all films and necrotic tissues and achieve optimal wound cleansing to accelerate its healing or for the subsequent stage of surgical treatment.

Information on technical characteristics, delivery set, country of manufacture