Artelak splash ophthalmic solution, 10ml

• For intensive and long-term moisturizing of the anterior surface of the eye (cornea and conjunctiva) at:

  - dryness of the eyes caused by lifestyle, stressful loads on the eyes, exposure to environmental factors, such as prolonged work at the computer and, as a result, rare blinking, being in an air-conditioned room, cigarette smoke, strong wind;

  - with severe dry eyes caused by systemic diseases, eye surgery or taking certain medications, such as contraceptives, antihistamines, beta-blockers, antispasmodics, diuretics.

• to eliminate discomfort when wearing hard and soft contact lenses.

It is recommended to instill ArtelacЃ Splash into the conjunctival sac of each eye, 1 drop as needed.

Mode of application

How to use ArtelacЃ Splash

Thanks to the specially designed pumping mechanism of the bottle, the solution remains sterile without preservatives. The pictures show how ArtelakЃ Splash should be applied.

1. Every time before using the solution, it is necessary to remove the protective cap of the bottle. Do not touch the tip of the bottle with your fingers.

2. Place your thumb and forefinger on the circular dispenser plate near the tip of the bottle, and place your little finger on the bottom of the bottle. Fingers located in the middle, you can support the bottle on the sides.

3. Before using the pumping device for the first time, you must press the dispenser plate about 7 times before the first drop appears. Hold the bottle as shown in the figure.

4. To drip the solution, you should tilt your head back and hold the bottle over the eye as it is convenient. Gently pull back the lower eyelid with the finger of your free hand, hold the bottle in an upright position and lightly press the dispenser plate. After that, close your eyes and slowly move your eyes in all directions so that the drop is distributed over the surface of the eye.

5. After each use, the bottle must be closed with a cap.

6. You can help yourself with the other hand for more precision, if needed.

Do not allow the tip of the bottle to touch the eye and touch it with your fingers to prevent contamination of the solution.

Ophthalmic moisturizing solution 1 ml

hyaluronic acid (in the form of sodium hyaluronate) 2.4 mg

Excipients: potassium chloride, sodium chloride, disodium phosphate dodecahydrate, sodium dihydrogen phosphate dihydrate, water d / i.

Hypersensitivity to any of the components that make up the solution (local allergic reactions that occur in rare cases). In such cases, the drug should be discontinued.

Properties

ArtelacЃ Splash contains hyaluronic acid (sodium hyaluronate), which is a natural moisturizer with a high ability to bind to water.

The lacrimal fluid is made up of three layers that provide the surface of the eye with nutrients, form a protective lubricating barrier between the eyelid and the cornea, and ensure normal functioning and clear vision.

A natural tear film is distributed over the surface of the eye with each blink, protecting the eyes from drying out and promoting healing of superficial corneal injuries. If the balance of the composition of the tear film is disturbed, a sensation of dryness, burning, a foreign body in the eye, irritation and redness of the eyes, a feeling of fatigue, and in some cases lacrimation may occur.

ArtelacЃ Splash solution moisturizes the eyes for a long time and helps stabilize the tear film for a healthy eye surface.

ArtelakЃ Splash does not contain preservatives.

special instructions

When wearing soft and hard contact lenses, ArtelacЃ Splash can be instilled into the conjunctival sac without removing the lenses.

Do not use the drug if the package is damaged.